Service Centers in Ellsworth & Osceola, WI   |   Fireplace Showrooms in Hudson, WI & Hastings, MN  Call Comfort By Design for your Geothermal repair in Hastings MN.
Have your fireplace repaired by an experienced technician in Ellsworth WI
Like us on facebook for more info on our AC repair service in Hudson WI
Check out our Geothermal repair videos on Youtube for Hastings MN
Heating • Cooling • Geothermal • Electrical • Plumbing • Fireplaces
Heating • Cooling • Geothermal • Electrical • Plumbing • Fireplaces
(800) 370-6545

Practical Advice & Suggestions

You can avoid costly and inconvenient breakdowns through preventive maintenance.

There is nothing quite so irritating as when something we depend on breaks down.

Take the following maintenance related quiz:











True or False: The cost and inconvenience of most breakdowns can be avoided with proper maintenance.
True or False: Every equipment manufacturer recommends annual maintenance to ensure proper operation.
True or False: Every ten minutes that your gas furnace runs it unleashes the equivalent energy of 3.5 sticks of dynamite.
True or False: If you drove your car for as many hours as a typical furnace runs, your car would have had enough time to drive almost 100,000 miles.

All of the above statements are true and it is why Comfort By Design puts an emphasis on annual preventive maintenance. The precision tune-up specialist who maintains your equipment will thoroughly check it for safety and operational efficiency, tune it up for maximum fuel efficiency, and inspect it for potential faults. This saves you money by reducing your fuel bill, by avoiding costly breakdowns, and by prolonging the life of your equipment.

Preventive maintenance doesn’t cost….

It pays.

With Freier’s Electric and Heating you have the ability to purchase one of the most comprehensive service agreements available anywhere.


Call for information regarding different programs and options available.  A brief description can be found below for your Heating and/or Air Conditioning equipment.


Tune-up Procedures

§    Clean and check condensing coil

§    Test and adjust operating pressures

§    Test starting capabilities

§    Test and adjust blower components

§    Lubricate necessary moving parts.

§    Test all safety controls/devices

§    Clean & inspect heat exchanger(s), burners, and pilot assemblies.

§    Clean or replace filters

§    Clean condensate drain

§    Test voltage of motors

§    Test Amp draw on motors

§    Calibrate thermostat

§    Measure temperature difference

§    Clean evaporator coil if accessible

§    Check gas pressure

§    Test in heat cycle


Additional Benefits

 §    Improved efficiency

§    Restored capacity

§    Extended equipment life

§    Priority Customer Service

§    Inflation Protection

§    Maintenance report in your file